Siemens SINAMICS DCM - CO: CUD Analog Input 3 Raw Value; CUD AI 3 Raw; CO: CUD Analog Input Select Input 1; CUD AI Sel 1; CO: CUD Analog Input Select Input 2; CUD AI Sel 2; CO: CUD Analog Input Select Input 2 Raw Value; CUD AI Sel 2 Raw

2 Parameters
2.2 List of parameters
SINAMICS DCM
562 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Display and connector output for the analog "Select input 1" (X177.27/28).
Description: Display and connector output for the raw value at the analog "Select input 2" (X177.29/30).
Description: Display and connector output for the analog "Select input 2" (X177.29/30).
Description: Display and connector output for the raw value at analog input 3 (X177.1/2) on the CUD.
Dependency: Refer to: r52019
Note: AI: Analog Input
Description: Display and connector output for the conversion result at analog input 3 (X177.1/2) on the CUD.
r52015 CO: CUD analog input select input 1 / CUD AI sel 1
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2080
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52016 CO: CUD analog input select input 2 raw value / CUD AI sel 2 raw
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2080
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52017 CO: CUD analog input select input 2 / CUD AI sel 2
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2080
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52018 CO: CUD analog input 3 raw value / CUD AI 3 raw
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2085
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52019 CO: CUD analog input 3 result / CUD AI 3 res
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2085
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]