Siemens SINAMICS DCM - Automatic Calculation Motor;Control Parameters; Calc Auto Par; Firmware Package Name; FW Pkg Name; Power Unit Code Number; PU Code no; Power Unit Code Number Actual; PU Code No. Act

2 Parameters
2.2 List of parameters
SINAMICS DCM
62 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Displays the unique code number of the power unit.
Note: r0200 = 0: No power unit found
Description: Code number of the power unit.
Each time the system boots, the code number is transferred from the data of the power unit to r0200 and to p0201.
Description: Displays the name of the firmware package on the memory card/device memory.
r0203[0]: Name character 1
...
r0203[15]: Name character 16
For the commissioning software, the ASCII characters are displayed uncoded.
Notice: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
Description: Setting to automatically calculate motor parameters and closed-loop control parameters from rating plate data.
Value: 0: No calculation
1: Complete calculation
Notice: After the value has been modified, no further parameter modifications can be made and the status is shown in r3996.
Modifications can be made again when r3996 = 0.
r0200[0...n] Power unit code number actual / PU code no. act
DC_CTRL,
DC_CTRL_R,
DC_CTRL_R_S,
DC_CTRL_S
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: PDS Func. diagram: -
P-Group: Converter Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
p0201[0...n] Power unit code number / PU code no
DC_CTRL,
DC_CTRL_R,
DC_CTRL_R_S,
DC_CTRL_S
Can be changed: C2 Calculated: - Access level: 4
Data type: Unsigned16 Dyn. index: PDS Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 65535 0
r0203[0...15] Firmware package name / FW pkg name
CU_DC, CU_DC_R,
CU_DC_R_S,
CU_DC_S
Can be changed: - Calculated: - Access level: 4
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
p0340[0...n] Automatic calculation motor/control parameters / Calc auto par
DC_CTRL,
DC_CTRL_R,
DC_CTRL_R_S,
DC_CTRL_S
Can be changed: C2(3), T Calculated: - Access level: 3
Data type: Integer16 Dyn. index: DDS, p0180 Func. diagram: -
P-Group: Motor Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0