Siemens SINAMICS DCM List Manual

2 Parameters
2.2 List of parameters
SINAMICS DCM
554 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Setting to activate/de-activate fuse monitoring on the Control Module.
Value: 0: Deactivated
1: Activated
Index: [0] = Connector X23B
[1] = Connector X23C
[2] = Connector X23D
[3] = Connector X23E
[4] = Connector X23F
Dependency: Refer to: F60004, F60204
Note: The parameter is only effective on the Control Module.
Connector X23B is available on the power interface and on the expansion module (A7112 module). Monitoring at
connectors X23C to X23F is only possible using the expansion module.
Only groups of up to 6 inputs can be activated and de-activated at the same time.
If an expansion module is connected to slot X23A, slot X23B cannot be used on the power interface.
Description: Sets the configuration for fan monitoring on the Control Module.
Value: 0: OFF
1: ON and Low active
2: ON and High active
Dependency: Refer to: r53140
Refer to: A60266, F60267
Note: Fan monitoring is wired via input terminal 122/123.
The parameter can only be changed for the Control Module.
Description: Sets the mode to trigger the external fault F60203 via input terminal 124/125 on the Control Module.
Value: 0: Switched off
1: Switched on and Low level triggers fault
2: Switched on and High level triggers fault
Dependency: Refer to: r53140
Refer to: F60203
p51831[0...4] Fuse monitoring activation / Fuse mon act
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: - Func. diagram: 6957, 6965
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
p51832 Fan monitoring configuration / Fan mon config
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: - Func. diagram: 8049
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 2 1
p51833 External fault mode / Ext F mode
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: - Func. diagram: 6965, 8049
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 2 1

Siemens SINAMICS DCM Specifications

General

Brand	Siemens
Model	SINAMICS DCM
Category	Media Converter
Language	English