SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
453
2 Parameters
2.2 List of parameters
Description: Sets fixed value 5.
Dependency: Refer to: r52405
Note: This value can be interconnected via connector output r52405.
Description: Sets fixed value 6.
Dependency: Refer to: r52406
Note: This value can be interconnected via connector output r52406.
Description: Sets fixed value 7.
Dependency: Refer to: r52407
Note: This value can be interconnected via connector output r52407.
Description: Sets fixed value 8.
Dependency: Refer to: r52408
Note: This value can be interconnected via connector output r52408.
p50405[0...n] Fixed value 5 / Fix val 5
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
p50406[0...n] Fixed value 6 / Fix val 6
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
p50407[0...n] Fixed value 7 / Fix val 7
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
p50408[0...n] Fixed value 8 / Fix val 8
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
To Next Page
Loading...
