SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
457
2 Parameters
2.2 List of parameters
Description: Sets the signal level for fixed bit 4.
Value: 0: Low
1: High
Dependency: Refer to: r53230
Note: This signal can be interconnected via binector output r53230.4.
Description: Sets the signal level for fixed bit 5.
Value: 0: Low
1: High
Dependency: Refer to: r53230
Note: This signal can be interconnected via binector output r53230.5.
Description: Sets the signal level for fixed bit 6.
Value: 0: Low
1: High
Dependency: Refer to: r53230
Note: This signal can be interconnected via binector output r53230.6.
Description: Sets the signal level for fixed bit 7.
Value: 0: Low
1: High
Dependency: Refer to: r53230
Note: This signal can be interconnected via binector output r53230.7.
p50425[0...n] Fixed bit 4 / Fixed bit 4
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
p50426[0...n] Fixed bit 5 / Fixed bit 5
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
p50427[0...n] Fixed bit 6 / Fixed bit 6
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
p50428[0...n] Fixed bit 7 / Fixed bit 7
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
To Next Page
Loading...
