Siemens SINAMICS DCM - BI: CUD Analog Input 2 Inversion; CUD AI 2 Inv; CUD Analog Input 2 Offset; CUD AI 2 Offs; CUD Analog Input 2 Signal Processing; CUD AI 2 Sig Proc; CUD Analog Input 2 Smoothing Time Constant; CUD AI 2 T

SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
505
2 Parameters
2.2 List of parameters
Description: Sets the offset for analog input 2 (X177.29/30) on the CUD.
Description: Sets the signal processing mode for analog input 2 (X177.29/30) on the CUD.
Value: 0: Signal not controlled
1: Signal absolute value generation
2: Signal inverted
3: Signal absolute value generation inverted
Description: Sets the signal source for inverting the signal from analog input 2 (X177.29/30) on the CUD.
1 signal: Inversion
0 signal: No inversion
Description: Sets the time constant for smoothing the signal from analog input 2 (X177.29/30) on the CUD.
Description: Sets the signal source for enabling analog input 2 (X177.29/30) on the CUD.
p50722 CUD analog input 2 offset / CUD AI 2 offs
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2080
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
p50723 CUD analog input 2 signal processing / CUD AI 2 sig proc
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Integer16 Dyn. index: - Func. diagram: 2080
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 3 0
p50724 BI: CUD analog input 2 inversion / CUD AI 2 inv
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 2080
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0
p50725 CUD analog input 2 smoothing time constant / CUD AI 2 T
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 2080
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 [ms] 10000 [ms] 0 [ms]
p50726 BI: CUD analog input 2 signal source for enable / CUD AI 2 ena sig s
DC_CTRL Can be changed: T Calculated: - Access level: 2
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 2080
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 1