Siemens SINAMICS DCM List Manual

2 Parameters
2.2 List of parameters
SINAMICS DCM
632 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Display and connector output for the overload monitoring of the digital outputs.
Dependency: For bits 04 to 07:
The terminal must be set as an output (p50789[0...3] = 1).
Note: DO: Digital Output
DI/DO: Bidirectional Digital Input/Output
Description: Displays the state of the messages for speed comparisons and limits.
r53021.0...7 CO/BO: CUD digital outputs overload monitoring / CUD DO overload
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 2055, 2060,
2065
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DO 0 (X177.19) overload present Yes No 2055
01 DO 1 (X177.20) overload present Yes No 2055
02 DO 2 (X177.21) overload present Yes No 2055
03 DO 3 (X177.22) overload present Yes No 2055
04 DI/DO 4 (X177.15) overload present Yes No 2060
05 DI/DO 5 (X177.16) overload present Yes No 2060
06 DI/DO 6 (X177.17) overload present Yes No 2065
07 DI/DO 7 (X177.18) overload present Yes No 2065
r53025.0...13 CO/BO: Speed messages / n messages
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: Unsigned16 Dyn. index: - Func. diagram: 8020, 8025
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Setpoint/actual value deviation 1 less than
threshold
Yes No 8020
01 Setpoint/actual value deviation 1 less than
threshold inverted
Yes No 8020
02 Setpoint/actual value deviation 2 less than
threshold
Yes No 8020
03 Setpoint/actual value deviation 2 less than
threshold inverted
Yes No 8020
04 Comparison setpoint reached Yes No 8020
05 Comparison setpoint reached inverted Yes No 8020
06 Deceleration speed reached Yes No 8020
07 Deceleration speed reached inverted Yes No 8020
08 Positive speed setpoint Yes No 8025
09 Positive speed setpoint inverted Yes No 8025
10 Overspeed Yes No 8025
11 Overspeed inverted Yes No 8025
12 Positive speed actual value Yes No 8025
13 Positive speed actual value inverted Yes No 8025

Siemens SINAMICS DCM Specifications

General

Brand	Siemens
Model	SINAMICS DCM
Category	Media Converter
Language	English