Siemens SINAMICS DCM - CO: Cl-Loop Field Curr Control Curr Controller Integral Comp; CO: Cl-Loop Field Curr Control Curr Controller Proportional Comp; CO: Cl-Loop Field Curr Ctrl Prectr and Field Curr Controller Output; CO: Closed-Loop Field Current Control Current Controller Output

SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
587
2 Parameters
2.2 List of parameters
Description: Display and connector output of the output value from pre-control and the field current controller.
Description: Display and connector output for the output in the case of closed-loop field current control.
Description: Display and connector output for the proportional component in the case of closed-loop field current control.
Description: Display and connector output for the integral component in the case of closed-loop field current control.
Description: Display and connector output for the setpoint/actual value difference in the case of closed-loop field current control.
r52252 CO: Cl-loop field curr ctrl prectr and field curr controller output / If_ctr prec+ctrl
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6910
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52260 CO: Closed-loop field current control current controller output / If_ctr I_ctr outp
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6910
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52261 CO: Cl-loop field curr control curr controller proportional comp / If_ctr I_ctr P com
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6910
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52262 CO: Cl-loop field curr control curr controller integral comp / If_ctr I_ctr I com
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6910
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52263 CO: Cl-loop field curr ctrl current controller set/act val diff / If_ctr I_ctr dif
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6910
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]