SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
19
2 Parameters
2.1 Overview of parameters
Calculated
Specifies whether the parameter is influenced by automatic calculations.
The calculation attribute defines which activities influence the parameter.
The following attributes apply:
• CALC_MOD_ALL
– p0340 = 1
• CALC_MOD_CON
– p0340 = 1
• CALC_MOD_EQU
– p0340 = 1
• CALC_MOD_LIM_REF
– p0340 = 1, 5
• CALC_MOD_REG
– p0340 = 1, 3
Access level
Specifies the minimum access level required to be able to display and change the relevant
parameter. The required access level can be set using p0003.
The system uses the following access levels:
• 1: Standard
• 2: Extended
• 3: Expert
• 4: Service
Parameters with this access level are password protected.
Note:
For p3900 > 0, p0340 = 1 is also called automatically.
Note
Parameter p0003 is CU-specific (belongs to the Control Unit).
A higher access level will also include the functions of the lower levels.
To Next Page
Loading...
