Siemens SINAMICS DCM - CO: Speed Controller Torque Setpoint; N_Ctr Tq Set; CO: Torque Actual Value in Relation to P50100 * P50102; Tqe Act Ref; CO: Torque Limiting Setpoint before Limiting (with Add_S); CO: Torque Limiting Setpoint before Limiting (Without Add_S)

SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
575
2 Parameters
2.2 List of parameters
Description: Display and connector output for the torque setpoint before limiting (with additional setpoint).
Description: Display and connector output for the torque setpoint before limiting (without additional setpoint).
Description: Display and connector output for the speed controller's output value with friction and inertia compensation and
additional torque setpoint.
Description: Display and connector output for the torque actual value referenced to p50100 * p50102.
Description: Display and connector output for the setpoint change on the speed controller.
Dependency: Refer to: p50540, r52174
r52145 CO: Torque limiting setpoint before limiting (with add_s) / Set bef lim w add
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6830
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52147 CO: Torque limiting setpoint before limiting (without add_s) / Set b lim w/o add
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6830, 6840
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52148 CO: Speed controller torque setpoint / n_ctr tq set
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6815
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52149 CO: Torque actual value in relation to p50100 * p50102 / Tqe act ref
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6851
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52150 CO: Speed controller setpoint change / n_ctr set chng
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6820
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]