SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
611
2 Parameters
2.2 List of parameters
Description: Display and connector output of the word-by-word receive data from slave 11 on the parallel interface.
Index: [0] = Word 1
[1] = Word 2
[2] = Word 3
[3] = Word 4
[4] = Word 5
[5] = Word 6
[6] = Word 7
[7] = Word 8
[8] = Word 9
[9] = Word 10
[10] = Word 11
[11] = Word 12
[12] = Word 13
[13] = Word 14
[14] = Word 15
[15] = Word 16
Dependency: Refer to: r52731
Note: The receive data in word 1 is also available in non-scaled format bit by bit and word by word for further
interconnection.
Description: Display and connector output of the word-by-word receive data from slave 12 on the parallel interface.
Index: [0] = Word 1
[1] = Word 2
[2] = Word 3
[3] = Word 4
[4] = Word 5
[5] = Word 6
[6] = Word 7
[7] = Word 8
[8] = Word 9
[9] = Word 10
[10] = Word 11
[11] = Word 12
[12] = Word 13
[13] = Word 14
[14] = Word 15
[15] = Word 16
Dependency: Refer to: r52732
Note: The receive data in word 1 is also available in non-scaled format bit by bit and word by word for further
interconnection.
r52711[0...15] CO: Parallel interface slave 11 receive data word by word / Slave11 recv wbw
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 9352
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52712[0...15] CO: Parallel interface slave 12 receive data word by word / Slave12 recv wbw
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 9352
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
To Next Page
Loading...
