2 Parameters
2.2 List of parameters
SINAMICS DCM
454 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Sets fixed value 9.
Dependency: Refer to: r52409
Note: This value can be interconnected via connector output r52409.
Description: Sets fixed value 10.
Dependency: Refer to: r52410
Note: This value can be interconnected via connector output r52410.
Description: Sets fixed value 11.
Dependency: Refer to: r52411
Note: This value can be interconnected via connector output r52411.
Description: Sets fixed value 12.
Dependency: Refer to: r52412
Note: This value can be interconnected via connector output r52412.
p50409[0...n] Fixed value 9 / Fix val 9
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
p50410[0...n] Fixed value 10 / Fix val 10
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
p50411[0...n] Fixed value 11 / Fix val 11
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.00 [%] 200.00 [%] 0.00 [%]
p50412[0...n] Fixed value 12 / Fix val 12
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-340.28235E36 [%] 340.28235E36 [%] 0.00 [%]