Siemens SINAMICS DCM - CI: EMF Controller Actual Value Signal Source; CI: EMF Controller Setpoint Signal Source; EMF Ctr Set Sig S; CI: Field Current Setpoint Limiting Sig Source for Var Lower Limit; CI: Field Gating Unit Signal Source for Field Direction

SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
487
2 Parameters
2.2 List of parameters
Description: Sets the signal sources for generating the lower limit of the field current setpoint (CO: r52274).
Dependency: Refer to: p50103, r52274
Description: Sets the signal source for the setpoints on the EMF controller.
Index: [0] = Setpoint 0
[1] = Setpoint 1
[2] = Setpoint 2
[3] = Setpoint 3
Dependency: Refer to: r52288
Note: The overall setpoint is available via connector output r52288 for further interconnection.
Description: Sets the signal source for the actual value on the EMF controller.
Dependency: Refer to: r52285
Note: The actual value is available via connector output r52285 for further interconnection.
Description: Sets the signal source for the field direction on the field gating unit.
p50614[0...4] CI: Field current setpoint limiting sig source for var lower limit / If_lim l lim sig s
DC_CTRL Can be changed: T Calculated: - Access level: 3
Data type: Unsigned32 / FloatingPoint32 Dyn. index: - Func. diagram: 6905
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- - [0...3] 1
[4] 0
p50615[0...3] CI: EMF controller setpoint signal source / EMF ctr set sig s
DC_CTRL Can be changed: T Calculated: - Access level: 3
Data type: Unsigned32 / FloatingPoint32 Dyn. index: - Func. diagram: 6900
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- - [0] 52289[0]
[1] 0
[2] 0
[3] 0
p50616 CI: EMF controller actual value signal source / EMF ctr act sig s
DC_CTRL Can be changed: T Calculated: - Access level: 3
Data type: Unsigned32 / FloatingPoint32 Dyn. index: - Func. diagram: 6900
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- - 52286[0]
p50618 CI: Field gating unit signal source for field direction / Field g unit dir
DC_CTRL Can be changed: T Calculated: - Access level: 3
Data type: Unsigned32 / FloatingPoint32 Dyn. index: - Func. diagram: 6915
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- - 52268[0]