Siemens SINAMICS DCM List Manual

2 Parameters
2.2 List of parameters
SINAMICS DCM
382 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Displays the speed setpoint from the Advanced Operator Panel 30 (AOP30).
Description: Displays the speed of the device fan.
Index: [0] = Fan 1 speed
[1] = Fan 2 speed
[2] = Fan 3 speed
[3] = Fan 4 speed
Dependency: Refer to: p50082, p50096
Refer to: F60167
Note: The following options are available, dependent upon the power unit used:
- No fans
- 2 DC fans
- 1 AC fan
- 2 AC fan
- 2 AC fans + 1 DC fan
Description: Displays the actual value of the field voltage.
Description: Displays the firing angle on the field circuit.
r50029 Speed setpoint AOP30 display / n_set AOP30 disp
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3113
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: p2000 Expert list: 1
Min Max Factory setting
- [1 rpm] - [1 rpm] - [1 rpm]
r50030[0...3] Device fan speed / Dev fan n
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 8047
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- [1 rpm] - [1 rpm] - [1 rpm]
r50033 Field voltage actual value / Uf act val
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6902
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- [V] - [V] - [V]
r50034 Field firing angle / Field fir angle
DC_CTRL Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6915
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- [°] - [°] - [°]

Siemens SINAMICS DCM Specifications

General

Brand	Siemens
Model	SINAMICS DCM
Category	Media Converter
Language	English