Siemens SINAMICS DCM - Messages for Overspeed Threshold Negative Direction of Rotation; Messages for Overspeed Threshold Positive Direction of Rotation; Messages for Setpoint;Actual Value Deviation 1 Threshold

SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
449
2 Parameters
2.2 List of parameters
Description: Sets the threshold for the maximum speed in positive direction of rotation.
Dependency: Refer to: p50381, p50595, r53025
Refer to: F60038
Note: The "Overspeed" message is available as follows:
- F60038
- r53025.10 (not inverted)
- r53025.11 (inverted)
Description: Sets the threshold for the maximum speed in negative direction of rotation.
Dependency: Refer to: p50380, p50595, r53025
Refer to: F60038
Note: The "Overspeed" message is available as follows:
- F60038
- r53025.10 (not inverted)
- r53025.11 (inverted)
Description: Sets the threshold for the "Setpoint/actual value deviation 1 reached" message.
Dependency: Refer to: p50389, p50390, p50590, p50591, r53025
Refer to: F60031
Note: The "Setpoint/actual value deviation 1 reached" message is available as follows:
- F60031
- r53025.0 (not inverted)
- r53025.1 (inverted)
p50380[0...n] Messages for overspeed threshold positive direction of rotation / Msg n_over pos
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 8025
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
0.0 [%] 200.0 [%] 120.0 [%]
p50381[0...n] Messages for overspeed threshold negative direction of rotation / Msg n_over neg
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 8025
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
-200.0 [%] 0.0 [%] -120.0 [%]
p50388[0...n] Messages for setpoint/actual value deviation 1 threshold / Set/act 1 thresh
DC_CTRL Can be changed: U, T Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: DDS, p0180 Func. diagram: 8020
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
0.00 [%] 200.00 [%] 3.00 [%]