EasyManua.ls Logo

Siemens SINAMICS DCM - CO;BO: Power Unit I2 T State; PU I2 T State; CO;BO: Power Unit Properties; PU Properties; CO;BO: Thyristor Blocking State; Thyr Block State

Siemens SINAMICS DCM
1204 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
637
2 Parameters
2.2 List of parameters
Description: Displays the blocked state of the thyristors.
Note: The blocked state is only relevant for the state "non-conducting" (r53146.x = 0).
Description: Displays the state of the I2t monitoring of the power unit.
Description: Display and BICO output for properties of the power unit.
r53147.0...13 CO/BO: Thyristor blocking state / Thyr block state
DC_CTRL Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: 6950
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Thyristor X11 Blocking Inhibited -
01 Thyristor X12 Blocking Inhibited -
02 Thyristor X13 Blocking Inhibited -
03 Thyristor X14 Blocking Inhibited -
04 Thyristor X15 Blocking Inhibited -
05 Thyristor X16 Blocking Inhibited -
08 Thyristor X21 Blocking Inhibited -
09 Thyristor X22 Blocking Inhibited -
10 Thyristor X23 Blocking Inhibited -
11 Thyristor X24 Blocking Inhibited -
12 Thyristor X25 Blocking Inhibited -
13 Thyristor X26 Blocking Inhibited -
r53148.0...1 CO/BO: Power unit I2t state / PU I2t state
DC_CTRL Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: 8042
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 I2t power unit response threshold exceeded Yes No 8042
01 I2t power unit response threshold exceeded
and saved
Yes No 8042
r53149.0 CO/BO: Power unit properties / PU properties
DC_CTRL Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: 6840, 6960,
6965
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 4Q power unit Yes No 6960

Table of Contents

Other manuals for Siemens SINAMICS DCM

Related product manuals