Siemens SINAMICS DCM - PROFINET IP of Station; PN IP of Station; PROFINET Name of Station; PN Name of Station

SINAMICS DCM
List Manual (LH8), 02/2015, 6RX1800-0ED76
645
2 Parameters
2.2 List of parameters
Dependency: Refer to: p51790
Description: Displays PROFINET Name of Station.
Notice: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
Description: Displays PROFINET IP of Station.
Bit field: Bit Signal name 1 signal 0 signal FP
00 Power unit topology 1 Requested Not requested 9360
01 Power unit topology 2 Requested Not requested 9360
r61000[0...239] PROFINET Name of Station / PN Name of Station
CU_DC (PROFINET
CBE20), CU_DC_R
(PROFINET CBE20),
CU_DC_R_S
(PROFINET CBE20),
CU_DC_S
(PROFINET CBE20)
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dyn. index: - Func. diagram: 2410
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r61001[0...3] PROFINET IP of Station / PN IP of Station
CU_DC (PROFINET
CBE20), CU_DC_R
(PROFINET CBE20),
CU_DC_R_S
(PROFINET CBE20),
CU_DC_S
(PROFINET CBE20)
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dyn. index: - Func. diagram: 2410
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -