Siemens SINAMICS DCM - CO: Fixed Value 14; Fix Val 14; CO: Fixed Value 15; Fix Val 15; CO: Fixed Value 16; Fix Val 16; CO: Speed Controller Start Pulse Positive Setpoint; Start Pul Pos Set

2 Parameters
2.2 List of parameters
SINAMICS DCM
600 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Connector output for fixed value 14 set in p50414.
Dependency: Refer to: p50414
Description: Connector output for fixed value 15 set in p50415.
Dependency: Refer to: p50415
Description: Connector output for fixed value 16 set in p50416.
Dependency: Refer to: p50416
Description: Display and connector output for the positive setpoint of the start pulse on the speed controller.
Description: Display and connector output for the negative setpoint of the start pulse on the speed controller.
The setpoint is evaluated via p51652.
Dependency: Refer to: p51652
r52414 CO: Fixed value 14 / Fix val 14
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52415 CO: Fixed value 15 / Fix val 15
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52416 CO: Fixed value 16 / Fix val 16
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 3100
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52451 CO: Speed controller start pulse positive setpoint / Start pul pos set
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6800
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]
r52452 CO: Speed controller start pulse negative setpoint evaluated / Start pul neg set
DC_CTRL Can be changed: - Calculated: - Access level: 2
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 6800
P-Group: - Unit group: - Unit selection: -
Not for motor type: - Scaling: PERCENT Expert list: 1
Min Max Factory setting
- [%] - [%] - [%]