Siemens SINAMICS DCM - BI: TM15 DI;DO Signal Source for Terminal DI;DO 5; TM15 D S_Src DI;DO5; BI: TM15 DI;DO Signal Source for Terminal DI;DO 6; TM15 D S_Src DI;DO6; BI: TM15 DI;DO Signal Source for Terminal DI;DO 8; TM15 D S_Src DI;DO8

2 Parameters
2.2 List of parameters
SINAMICS DCM
218 List Manual (LH8), 02/2015, 6RX1800-0ED76
Description: Sets the signal source for terminal DI/DO 5 (X520.7) of Terminal Module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.5 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 6 (X520.8) of Terminal Module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.6 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 7 (X520.9) of Terminal Module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.7 = 1).
DI/DO: Bidirectional Digital Input/Output
Description: Sets the signal source for terminal DI/DO 8 (X521.2) of terminal module 15 (TM15).
Note: Prerequisite: The DI/DO must be set as an output (p4028.8 = 1).
DI/DO: Bidirectional Digital Input/Output
p4035 BI: TM15DI/DO signal source for terminal DI/DO 5 / TM15D s_src DI/DO5
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9400
P-Group: Commands Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0
p4036 BI: TM15DI/DO signal source for terminal DI/DO 6 / TM15D s_src DI/DO6
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9400
P-Group: Commands Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0
p4037 BI: TM15DI/DO signal source for terminal DI/DO 7 / TM15D s_src DI/DO7
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9400
P-Group: Commands Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0
p4038 BI: TM15DI/DO signal source for terminal DI/DO 8 / TM15D s_src DI/DO8
TM15DI_DO Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 / Binary Dyn. index: - Func. diagram: 9401
P-Group: Commands Unit group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0