2 Parameters
2.2 List of parameters
SINAMICS DCM
320 List Manual (LH8), 02/2015, 6RX1800-0ED76
[27] = PZD 28
[28] = PZD 29
[29] = PZD 30
[30] = PZD 31
[31] = PZD 32
[32] = PZD 33
[33] = PZD 34
[34] = PZD 35
[35] = PZD 36
[36] = PZD 37
[37] = PZD 38
[38] = PZD 39
[39] = PZD 40
[40] = PZD 41
[41] = PZD 42
[42] = PZD 43
[43] = PZD 44
[44] = PZD 45
[45] = PZD 46
[46] = PZD 47
[47] = PZD 48
[48] = PZD 49
[49] = PZD 50
[50] = PZD 51
[51] = PZD 52
[52] = PZD 53
[53] = PZD 54
[54] = PZD 55
[55] = PZD 56
[56] = PZD 57
[57] = PZD 58
[58] = PZD 59
[59] = PZD 60
[60] = PZD 61
[61] = PZD 62
[62] = PZD 63
[63] = PZD 64
Dependency: Refer to: r8860, r8890, r8891, r8892, r8893
Notice: Where there is a multiple interconnection of a connector output, all the connector inputs must either have Integer or
FloatingPoint data types.
A BICO interconnection for a single PZD can only take place either on r8850 or r8860.
Note: IF2: Interface 2
PZD1 to PZD4 are displayed bit-serially in r8890 to r8893.
Description: Connector output for interconnecting the PZD (setpoints) received via interface 2 in the word format.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
Note: IF2: Interface 2
PZD1 to PZD2 are displayed bit-serially in r8890 to r8891.
r8850[0...4] CO: IF2 PZD receive word / IF2 PZD recv word
TM150, TM15DI_DO,
TM31
Can be changed: - Calculated: - Access level: 3
Data type: Integer16 Dyn. index: - Func. diagram: 2491
P-Group: Communications Unit group: - Unit selection: -
Not for motor type: - Scaling: 4000H Expert list: 1
Min Max Factory setting
- - -
To Next Page
Loading...
