Xerox Phaser 7100

Error Troubleshooting
Xerox Internal Use Only Phaser 7100 Service Manual 2-77
124-361 One of CRUM Enable/Disable settings is different from the others (IOT). 2-388
124-362 One of CRUM Enable/Disable settings is different from the others (SYS 1). 2-389
124-363 One of CRUM Enable/Disable settings is different from the others (SYS 2). 2-390
124-372 IOT Controller Software Malfunction 2-398
124-373 IOT Manager Software Fail 2-398
124-374 IOT IM Device Driver Software Fail 2-398
124-380 All three CRUM destinations are not set (0 or different values are set)
#Case-(2).
2-399
124-381 One of CRUM destinations is different from the others (IOT) #Case-(2). 2-400
124-382 One of CRUM destinations is different from the others (SYS 1) #Case-(2). 2-401
124-383 One of CRUM destinations is different from the others (SYS 2) #Case-(2). 2-402
124-390 All three CRUM OEM destinations are not set (0 or different values are set)
#Case-(2)
2-397
124-391 One of CRUM OEM destinations is different from the others (IOT) #Case-
(2).
2-400
124-392 One of CRUM OEM destinations is different from the others (SYS 1) #Case-
(2).
2-401
124-393 One of CRUM OEM destinations is different from the others (SYS 2) #Case-
(2).
2-402
125
125-311 PSWcont Unexpected Error 2-403
127
127-310 Fatal Error of ESR Task 2-403
127-314 WSD Print Service-related Fatal Error 2-403
127-353 lpd-related Fatal Error 2-404
127-354 FTP Server Fatal Error 2-404
127-396 Mail I/O-related Fatal Error 2-404
127-398 IPP-related Fatal Error 2-404
127-399 JME-related Fatal Error 2-404
202
202-399 Timer Internal Error Detected by UI Cont 2-405
Error Message and Chain Link Code Display (Continued)
Chain Link Control Panel Message Go to Page