1 5 LEDs for state display
2 2 rotary switches for address setting (not used)
3 Label
4 2 communication interfaces RJ45 (PNIO1 and PNIO2)
Sign for XC version
1.3.8.1.1 Intended Purpose
The communication module is for PROFINET RT communication.
The PROFINET communication module includes an internal Ethernet switch. The connection to
the Ethernet can be established directly to the communication module. An additional switch is
not necessary.
The communication module is configured via the dual-port memory by means of a system con-
figurator. The configuration is saved in a non-volatile way on a flash EPROM.
For use in extreme ambient conditions (e.g. wider temperature and humidity range), a special
XC version of the device is available.
Communication Modules (AC500 Standard) > PROFINET
2019/04/17 3ADR010121, 13, en_US 135
To Next Page
Loading...
