CAUTION!
The process supply voltage must be included in the earthing concept (e. g.
earthing of the minus pole).
The internal supply voltage for the module's circuitry comes from the communication module
bus. The process voltage for the inputs/outputs is provided via ZP and UP.
WARNING!
Removal/Insertion under power
The devices are not designed for removal or insertion under power. Because of
unforeseeable consequences, it is not allowed to plug or unplug devices with
the power being ON.
Make sure that all voltage sources (supply and process voltage) are switched
off before you
– connect or disconnect any signal or terminal block
– remove, mount or replace a module.
Disconnecting any powered devices while energized in a hazardous location
could result in an electric arc, which could create a flammable ignition resulting
in fire or explosion.
Make sure that power is removed and that the area has been thoroughly
checked to ensure that flammable materials are not present prior to proceeding.
The devices must not be opened when in operation. The same applies to the
network interfaces.
NOTICE!
Risk of damaging the PLC modules!
Overvoltages and short circuits might damage the PLC modules.
– Make sure that all voltage sources (supply and process voltage) are
switched off before you begin with operations at the system.
– Never connect any voltages or signals to reserved terminals (marked with
---). Reserved terminals may carry internal voltages.
NOTICE!
Risk of influences to the connected sensors!
Some sensors may be influenced by the deactivated module outputs of DC522.
Connect a 470 W / 1 W resistor in series to inputs C8/C9 if they are used as fast
counter inputs to avoid any influences.
The module provides several diagnostic functions
Ä
Chapter 1.5.1.2.4.5 “State LEDs”
on page 339).
I/O Configuration and Parameterization
The DC541-CM module does not store configuration data itself. Configuration and parameteri-
zation are performed with Automation Builder software DC541-CM.
I/O Modules > Digital I/O Modules
2019/04/173ADR010121, 13, en_US338
To Next Page
Loading...
