ABB AC500 PLC - 1.7.6.2.4 Internal Data Exchange; 1.7.6.2.5 Addressing; 1.7.6.2.6 I;O Configuration; 1.7.6.2.7 Parameterization

Interface Pin Signal Description
8 NC not used
Shield Cable shield Functional earth
For further information regarding wiring and cable types see chapter Ethernet
Ä Chapter 2.6.4.10 “Ethernet Connection Details” on page 1288.
1.7.6.2.4 Internal Data Exchange
Parameter Value
Digital inputs (bytes) 3
Digital outputs (bytes) 3
Analog inputs (words) 4
Analog outputs (words) 2
Counter input data (words) 4
Counter output data (words) 8
1.7.6.2.5 Addressing
The module reads the position of the rotary switches only during power-up, i. e.
changes of the switch position during operation will have no effect until the next
module initialization.
1.7.6.2.6 I/O Configuration
The CI501-PNIO stores some PROFINET configuration parameters (I/O device identifier, I/O
device type and IP address configuration). No more configuration data is stored.
The analog/digital I/O channels are configured via software.
Details about configuration are described in Parameterization
Ä Chapter 1.7.6.2.7 “Parameteri-
zation” on page 1024.
1.7.6.2.7 Parameterization
Parameters of the Module
Name Value Internal value Internal value,
type
Default
Module ID
1
)
Internal 7000 WORD 7000
Parameter length Internal 25 BYTE 25
Error LED / Fail-
safe function see
table Error LED /
Failsafe function
On 0 BYTE 0
Off by E4 1
Device Specifications
Communication Interface Modules (S500) > PROFINET
2019/04/173ADR010121, 13, en_US1024