1.7.6.5.11 Ordering Data
Part No. Description Product Life Cycle Phase *)
1SAP 221 500 R0001 CI506-PNIO, PROFINET bus module
with 2 serial interfaces and
1 CANopen master interface
Active
1SAP 421 500 R0001 CI506-PNIO-XC, PROFINET bus
module with 2 serial interfaces and
1 CANopen master interface,
XC version
Active
*) For planning and commissioning of new installations use modules in Active
status only.
1.8 Accessories
1.8.1 AC500-eCo
1.8.1.1 CR2032 - Battery for Real-Time Clock
A standard lithium battery (type CR2032) is used to backup the real-time clock (RTC) in the
adaptors TA561-RTC
Ä
Chapter 1.8.1.3 “TA561-RTC - Real-time Clock Adaptor ” on page 1106
and TA562-RS-RTC
Ä
Chapter 1.8.1.6 “TA562-RS-RTC - Adaptor with Serial RS-485 (COM2)
and Real-time Clock ” on page 1114 during power failures.
The CPU monitors the discharge degree of the battery. An diagnoses message is output before
the battery condition becomes critical (about 2 weeks before). After the diagnosis message has
appeared, the battery should be replaced as soon as possible.
● The handling instructions of the battery manufacturer must be observed.
● The Material Safety Data Sheet (MSDS) of the battery manufacturer must be observed.
● Do not short-circuit or re-charge the battery! It can cause excessive heating and explosion.
● Do not disassemble the battery!
● Do not heat up the battery and not put into fire! Risk of explosion.
● Store the battery in a dry place.
● Recycle exhausted batteries meeting the environmental standards.
Intended Pur-
pose
Handling
Instruction
2019/04/17 3ADR010121, 13, en_US 1103
To Next Page
Loading...
Need help?
General
