1.8.3 S500-eCo
1.8.3.1 TA566 - Wall Mounting Accessory
The TA566 wall mounting accessory is used for mounting S500-eCo I/O modules and AC500-
eCo processor modules without DIN rail.
The TA566 is snapped into the back side of the device's housing
Ä
Chapter 2.5.3.2 “Mounting
and Demounting of S500-eCo I/O Modules” on page 1203.
Parameter Value
Weight 5 g
Dimensions 29 mm x 28 mm x 5 mm
Part No. Description Product Life Cycle Phase *)
1TNE 968 901 R3107 TA566, wall mounting acces-
sory, 100 pieces
Active
*) For planning and commissioning of new installations use modules in Active
status only.
1.8.3.2 TA563-TA565 - Terminal Blocks
These terminal blocks must only be used with AC500-eCo I/O Modules and
AC500-eCo processor modules.
The TA563-TA565 terminal blocks are used to connect process signals and process voltages to
AC500-eCo I/O modules and AC500-eCo processor modules (with -P extension inside their
type designator only). 3 different kind of terminal blocks are available:
● Screw terminals with cable insertion on the side
● Screw terminals with cable insertion on the front
● Spring terminals with cable insertion on the front
Of each kind, 2 sizes are available:
● Terminals with 9 poles
● Terminals with 11 poles.
There are 2 compatible variants of each kind and size.
Intended Pur-
pose
Handling
Instruction
Technical Data
Ordering Data
Intended Pur-
pose
2019/04/173ADR010121, 13, en_US1164
To Next Page
Loading...
