ABB AC500 PLC - Diagnosis

Internal value Operating modes for the analog inputs,
individually configurable
17 3-wire Pt1000, -50 °C...+400 °C
18 2-wire Ni1000 -50 °C...+150 °C
19 3-wire Ni1000 -50 °C...+150 °C
22 2-wire Ni100, -50 °C...+150 °C
23 3-wire Ni100, -50 °C...+150 °C
32 Analog input resistor 0 W...150 W
33 Analog input resistor 0 W...300 W
Diagnosis
E1...E4 d1 d2 d3 d4 Identifier
000...063
AC500
display
<− Display in
Class Comp Dev Mod Ch Err PS501
PLC
Browser
Byte 6
Bit 6...7
- Byte 3 Byte 4 Byte 5 Byte 6
Bit 0...5
PNIO
diagnosis
block
Class Interface Device Module Channel Error
Identifier
Error message Remedy
1
)
2
)
3
)
4
)
Module error
3 14 1...10 31 31 19 Checksum error in the
I/O module
Replace
I/O module
11 / 12 ADR 1...10
3 14 1...10 31 31 9 Overflow diagnosis
buffer
Restart
11 / 12 ADR 1...10
3 14 1...10 31 31 26 Parameter error Check
master
11 / 12 ADR 1...10
3 14 1...10 31 31 11 Process voltage too low Check
process
voltage
11 / 12 ADR 1...10
Channel error
4 14 1...10 1 0...1 48 Analog value overflow
at an analog input
Check
input value
or terminal
11 / 12 ADR 1...10
4 14 1...10 1 0...1 7 Analog value underflow
at an analog input
Check
input value
11 / 12 ADR 1...10
Remarks:
Device Specifications
I/O Modules > Analog I/O Modules
2019/04/17 3ADR010121, 13, en_US 411