19 3-wire Ni1000 -50 °C...+150 °C *)
*) In the operating modes with 3-wire configuration or with differential inputs, two adjacent
analog inputs belong together (e.g. the channels 0 and 1). In these cases, both channels are
configured in the desired operating mode. The lower address must be the even address
(channel 0). The next higher address must be the odd address (channel 1). The converted
analog value is available at the higher address (channel 1).
Channel Monitoring
Table 156: Table Settings channel monitoring:
Internal Value Check Channel
0 (default) Plausib(ility), cut wire, short circuit
3 Not used
Channel Parameters for the Analog Outputs (2x)
Name Value Internal value Internal value,
type
Default
Output 0,
Channel configu-
ration
Operation modes
of analog outputs
Ä
Table 157 “Tab
le Operation
modes of analog
outputs:”
on page 964
Operation modes
of analog outputs
Ä
Table 157 “Tab
le Operation
modes of analog
outputs:”
on page 964
BYTE 0
Output 0, Check
channel
Channel moni-
toring
Ä
Table 158 “
Table channel
monitoring:”
on page 964
Channel moni-
toring
Ä
Table 158 “
Table channel
monitoring:”
on page 964
BYTE 0
Output 0, Substi-
tute value
Substitute value
Ä
Table 159 “
Table Substitute
value:”
on page 964
Substitute value
Ä
Table 159 “
Table Substitute
value:”
on page 964
WORD 0
Output 1,
Channel configu-
ration
Operation modes
of analog outputs
Ä
Table 157 “Tab
le Operation
modes of analog
outputs:”
on page 964
Operation modes
of analog outputs
Ä
Table 157 “Tab
le Operation
modes of analog
outputs:”
on page 964
BYTE 0
Output 1, Check
channel
Channel moni-
toring
Ä
Table 158 “
Table channel
monitoring:”
on page 964
Channel moni-
toring
Ä
Table 158 “
Table channel
monitoring:”
on page 964
BYTE 0
Output 1, Substi-
tute value
Substitute value
Ä
Table 159 “
Table Substitute
value:”
on page 964
Substitute value
Ä
Table 159 “
Table Substitute
value:”
on page 964
WORD 0
Communication Interface Modules (S500) > PROFIBUS
2019/04/17 3ADR010121, 13, en_US 963
To Next Page
Loading...
