ABB AC500 PLC - 2.6.4.3 Terminals at the Terminal Unit

2.6.4.3 Terminals at the Terminal Unit
1.0
1.1
1.2
1.3
1.4
1.5
1.6
1.7
1.8
1.9
2.0
2.1
2.2
2.3
2.4
2.5
2.6
2.7
2.8
2.9
3.0
3.1
3.2
3.3
3.4
3.5
3.6
3.7
3.8
3.9
4.0
4.1
4.2
4.3
4.4
4.5
4.6
4.7
4.8
4.9
Front terminal, conductor connection vertically with respect to the printed circuit board.
Parameter Value
Type Front terminal
Degree of protection IP 20
Stripped conductor end 9 mm, min. 8 mm
Fastening torque 0.6 Nm
Needed tool Slotted screwdriver
Dimensions Blade diameter 3.5 mm
Terminal units with product index < C0 e. g. 1SAP 212 200 R0001 B0
Number of cores per terminal Conductor type Cross section
1 Solid 0.08 mm² to 2.5 mm²
1 Flexible 0.08 mm² to 2.5 mm²
1 with wire end ferrule Flexible 0.25 mm² to 1.5 mm²
2 Solid Not intended
2 Flexible Not intended
2 with TWIN wire end ferrule (length
10 mm) with plastic sleeve
Flexible 2 x 0.25 mm² or 2 x 0.5 mm² or
2 x 0.75 mm², with square cross-sec-
tion of the wire-end ferrule also
2 x 1.0 mm²
Terminal Units with Product Index ³ C0 , e. g. 1SAP 212 200 R0001 C0
Number of cores per terminal Conductor type Cross section
1 Solid 0.08 mm² to 2.5 mm²
1 Flexible 0.08 mm² to 2.5 mm²
Terminal type:
Screw-type Ter-
minal
System Assembly, Construction and Connection
AC500 (Standard) > Connection and Wiring
2019/04/173ADR010121, 13, en_US1274