ABB AC500 PLC - 1.6.2.2 FM502-CMS - Analog Measurements

1.6.2.2 FM502-CMS - Analog Measurements
● 16 fast analog inputs, up to 50k samples/s.
● Counting functions with different configurable modes, including incremental position encoder
and frequency input.
● 4 dedicated inputs/outputs for specific counting measurement functions, e.g. touch, set,
reset, start measurement.
● All unused inputs/outputs can be used with the specifications of standard inputs/outputs
range.
● Synchronous sampling between all analog channels and the counting input.
FM502-CMS is used for condition monitoring via fast analog signals. For direct connection to
processor module PM592-ETH and wiring, the function module terminal bases TF501-CMS or
TF521-CMS are available, enabling AC500 communication modules and AC500 I/O modules
Ä Chapter 1.2.2.1 “PM57x (-y), PM58x (-y) and PM59x (-y)” on page 65 Ä Chapter 1.1.2
“TF501-CMS and TF521-CMS - Function Module Terminal Bases ” on page 13.
For usage in extreme ambient conditions a XC version is available.
1 Processor module PM592-ETH
2 Allocation between terminal no. and signal name
3 16 green/red LEDs to display the signal states at the analog inputs A0-A15
4 4 yellow LEDs to display digital inputs DI0, DI1 and digital inputs/outputs DC2,DC3
5 3 yellow LEDs display encoder/counter inputs
6 1 green LED to display the state of the process supply voltage L+
7 1 green LED to display the state of 5 V supply voltage for encoder
8 2 red LEDs to display errors
9 Label
10 Function module terminal base
11 DIN rail
Sign for XC version
Device Specifications
Function Modules > S500
2019/04/17 3ADR010121, 13, en_US 675