NOTICE!
Attention:
All I/O channels (digital and analog) are protected against reverse polarity,
reverse supply, short circuit and continuous overvoltage up to 30 VDC.
Technical Data of the Analog Outputs
Parameter Value
Number of channels per module 2 configurable voltage or current outputs
Distribution of channels into groups 1 (2 channels per group)
Connection of the signals O0U- and O1U+ Terminals 13 and 15
Connection of the signals O0I+ and O1I+ Terminals 14 and 16
Output type Bipolar with voltage, unipolar with current
Resolution 12 bits or 11 bits plus sign
Conversion error of the analog values
caused by non-linearity, adjustment error at
factory and resolution within the normal
range
Typ. ±0.5 % of full scale
at 25 °C
Max. ±2 % of full scale
at 0 °C...+60 °C or EMC disturbances
Indication of the output signals No
Output Resistance (load) as current output 0 W...500 W
Output load ability as voltage output ±2 mA max.
Output data length 4 bytes
Relationship between output signal and hex
code
Ä
Chapter 1.5.2.1.4.8 “Output Ranges”
on page 434
Unused outputs Must not be connected and must be configured
as "unused"
Overvoltage protection Yes, up to 30 VDC
Max. cable length (conductor cross section
> 0.14 mm²)
Unshielded wire 10 m
Shielded wire 100 m
Ordering Data
Part No. Description Product Life Cycle Phase *)
1TNE 968 902 R1201 AO561, analog output module, 2 AO,
U/I
Active
1TNE 968 901 R3102 Terminal block TA563-11, 11 pins,
screw front, cable side, 6 pieces per
unit
Active
I/O Modules > Analog I/O Modules
2019/04/173ADR010121, 13, en_US436
To Next Page
Loading...
