ABB AC500 PLC - Channel Parameters for the Analog Outputs (2 x)

Internal value Operating modes of the analog inputs, individually configurable
19 3-wire Ni1000 -50 °C...+150 °C *)
*) In the operating modes with 3-wire configuration or with differential inputs, two adjacent
analog inputs belong together (e.g. the channels 0 and 1). In these cases, both channels are
configured in the desired operating mode. The lower address must be the even address
(channel 0). The next higher address must be the odd address (channel 1). The converted
analog value is available at the higher address (channel 1).
Table 168: Channel Monitoring
Internal Value Check Channel
0 (default) Plausib(ility), cut wire, short circuit
3 Not used
Channel Parameters for the Analog Outputs (2x)
Name Value Internal value Internal value,
type
Default
Output 0,
Channel configu-
ration
Table Operating
modes of the
analog outputs
Ä Further infor-
mation
on page 1029
Table Operating
modes of the
analog outputs
Ä Further infor-
mation
on page 1029
BYTE 0
Output 0, Check
channel
Table Channel
monitoring
Ä Table 170 “Ch
annel Monitoring”
on page 1029
Table Channel
monitoring
Ä Table 170 “Ch
annel Monitoring”
on page 1029
BYTE 0
Output 0, Substi-
tute value
Table Substitute
value
Ä Table 171 “Su
bstitute Value”
on page 1029
Table Substitute
value
Ä Table 171 “Su
bstitute Value”
on page 1029
WORD 0
Output 1,
Channel configu-
ration
Table Operating
modes of the
analog outputs
Ä Further infor-
mation
on page 1029
Table Operating
modes of the
analog outputs
Ä Further infor-
mation
on page 1029
BYTE 0
Output 1, Check
channel
Table Channel
monitoring
Ä Table 170 “Ch
annel Monitoring”
on page 1029
Table Channel
monitoring
Ä Table 170 “Ch
annel Monitoring”
on page 1029
BYTE 0
Output 1, Substi-
tute value
Table Substitute
value
Ä Table 171 “Su
bstitute Value”
on page 1029
Table Substitute
value
Ä Table 171 “Su
bstitute Value”
on page 1029
WORD 0
Device Specifications
Communication Interface Modules (S500) > PROFINET
2019/04/173ADR010121, 13, en_US1028