ABB AC500 PLC - Ordering Data

Parameter Value
Relay output voltage
Rated value 24 VDC or 120/240 VAC
Output delay
Switching 0 to 1 (max.) Typ. 10 ms
Switching 1 to 0 (max.) Typ. 10 ms
Output data length 2 bytes
Output current
Rated current per channel (max.) 2.0 A (24 VDC / 24 VAC / 48 VAC /
120 VAC / 240 VAC, only resistive loads)
2.0 A (24 VAC / 48 VAC / 120 VAC, only pilot
duty)
1.5 A (240 VAC, only pilot duty)
Rated current per group (max.) 10 A
Lamp load (max.) 200 W (230 VAC), 30 W (24 VDC)
Spark suppression with inductive AC loads Must be performed externally according to
driven load specification
Switching Frequencies
With resistive loads Max. 1 Hz
With inductive loads On Request
With lamp loads Max. 1 Hz
Output type Non-protected
Protection type External fuse on each channel
Rated protection fuse (for each channel) 5 A fast
Short-circuit-proof / Overload-proof No, should be provided by an external fuse
or circuit breaker
Overload message No
Output current limitation No
Connection of 2 outputs in parallel Not possible
Life time of relay contacts (cycles) 100.000 at rated load
Max. cable length
Shielded 500 m
Unshielded 150 m
Ordering Data
Part No. Description Product Life Cycle Phase *)
1SAP 231 300 R0000 DO573, digital output module, 16 DO,
relay output
Active
1TNE 968 901 R3101 Terminal block TA563-9, 9 pins, screw
front, cable side, 6 pieces per unit
Active
1TNE 968 901 R3102 Terminal block TA563-11, 11 pins,
screw front, cable side, 6 pieces per
unit
Active
Device Specifications
I/O Modules > Digital I/O Modules
2019/04/17 3ADR010121, 13, en_US 271