Part No. Description Product Life Cycle Phase *)
1TNE 968 903 R0203 TA571-SIM, input simulator for
PM55x and PM56x
Active
*) For planning and commissioning of new installations use modules in Active
status only.
1.8.1.9 TK504 - Programming Cable
● PC-side: USB connector type A
● AC500-side: 5-pole terminal block
● Length 3 m
TK504 programming cable connects the USB interface of a PC with the serial interface of pro-
cessor module PM55x and PM56x. It is used for programming purposes.
CAUTION!
Risk of communication faults!
The mechanical connection of TK504 may get lost due to mechanical vibration.
Use TK504 only for programming and debugging. A permanent usage is not
foreseen.
With AC500/AC500-eCo processor modules, only the ABB programming cables
TK50x can be used. Other cables may cause communication faults and must
not be used.
1.
Install the device driver for the programming cable (see
Ä
“Installation of Cable Driver”
on page 1128).
Once you have installed the device driver of the cable in your Windows
system, make sure that you use always the same USB port of your com-
puter. Otherwise, Windows will ask you to install the driver a second time
if you connect the cable to a different USB port of your computer.
2.
Connect the 5-pole terminal block of the TK504 to the processor module
Ä
Chapter
2.5.4.3 “Serial Interface COM2” on page 1212.
3. Plug the USB connector to an USB interface at your PC.
Parameter Value
Connector at the PC (USB interface) USB connector type A
Connector at the Processor Module Single conductors
Length 3 m
Ordering Data
Intended Pur-
pose
Electrical Con-
nection
Technical Data
2019/04/17 3ADR010121, 13, en_US 1127
To Next Page
Loading...
