Table 194: States of the 3 State LEDs of the CANopen Interfaces
LED Color OFF ON Flashing
CAN-RUN Yellow -- Device config-
ured, CANopen
Bus in OPERA-
TIONAL state
and cyclic data
exchange run-
ning
Flashing cycli-
cally:
CANopen Bus in
Pre-operational
state and slave is
being configured
Single flash:
CANopen Bus in
Stopped state.
CAN-STA Yellow No data trans-
mission
Channel is trans-
mitting data
--
CAN-ERR Red No error CANopen bus is
OFF
Flashing cycli-
cally:
Configuration
error
Single flash:
Error counter
overflow due to
too many error
frames
Double flash:
A Node-Guard or
a Heartbeat
event occurred
Table 195: State of the Power Supply LED
LED Color OFF ON Flashing
UP Green No process
voltage available
Process voltage
available
--
1.7.6.5.10 Technical Data
The System Data of AC500 and S500
Ä
Chapter 2.6.1 “System Data AC500” on page 1248 are
valid for standard version.
The System Data of AC500-XC
Ä
Chapter 2.7.1 “System Data AC500-XC” on page 1309 are
valid for the XC version.
Only additional details are therefore documented below.
Technical Data of the Module
Parameter Value
Process supply voltages UP
Rated value 24 VDC
Max. load for the terminals 10 A
Protection against reversed voltage Yes
Communication Interface Modules (S500) > PROFINET
2019/04/173ADR010121, 13, en_US1100
To Next Page
Loading...
