ABB AC500 PLC - Connection of Active-type Analog Sensors (Voltage) with Electrically Isolated Power Supply; Connection of Active-type Analog Sensors (Current) with Electrically Isolated Power Supply

Connection of Active-type Analog Sensors (Voltage) with Electrically Isolated Power Supply
UP
ZP
1.0
I0-
1.1
I1-
1.8
UP
1.9
ZP
PTC
2.0
I0+
2.1
I1+
2.8
UP
2.9
ZP
0 ... 10 V
-10 ... +10 V
+
-
U
IN
AGND
Fig. 35: Connection example
By connecting the sensor's negative pole of the output voltage to AGND, the
electrically isolated voltage source of the sensor is referred to ZP.
The following measuring ranges can be configured Ä Chapter 1.5.2.2.1.6 “Parameterization”
on page 463 Ä Chapter 1.5.2.2.1.9 “Measuring Ranges” on page 468
Voltage 0 V...10 V 1 channel used
Voltage -10 V...+10 V 1 channel used
The function of the LEDs is described under Displays Ä Chapter 1.5.2.2.1.7 “Diagnosis”
on page 466.
In order to avoid error messages or long processing times, it is useful to configure unused
analog input channels as "unused".
Connection of Active-type Analog Sensors (Current) with Electrically Isolated Power Supply
UP
ZP
1.0
I0-
1.1
I1-
1.8
UP
1.9
ZP
PTC
2.0
I0+
2.1
I1+
2.8
UP
2.9
ZP
U
IN
0 ... +20 mA
+4 ... +20 mA
+
-
Fig. 36: Connection example
Device Specifications
I/O Modules > Analog I/O Modules
2019/04/173ADR010121, 13, en_US458