ABB AC500 PLC - Connection of Analog Output Loads (Current)

Fig. 184: Connection of analog output loads (voltage)
The following measuring ranges can be configured Ä Chapter 1.7.4.1.7 “Parameterization”
on page 897 and Ä Chapter 1.7.4.1.9 “Measuring Ranges” on page 909
Voltage -10 V...+10 V Load ±10 mA max. 1 channel used
The function of the LEDs is described under Diagnosis and displays / Displays Ä Chapter
1.7.4.1.8 “Diagnosis and State LEDs” on page 903.
Unused analog outputs can be left open-circuited.
Connection of Analog Output Loads (Current)
The following figure shows the connection of output loads to the analog output AO0. Proceed
with the analog output AO1 in the same way.
Device Specifications
Communication Interface Modules (S500) > Modbus
2019/04/173ADR010121, 13, en_US894