ABB AC500 PLC - 1.1.1.3 Technical Data

NOTICE!
Risk of corrosion!
Unused connectors and slots may corrode if XC devices are used in salt-mist
environments.
Protect unused connectors and slots with TA535 protective caps for XC devices
TA535 Ä Chapter 1.8.4.6 “TA535 - Protective Caps for XC Devices”
on page 1172.
Terminal bases TB5x3-2ETH for processor modules PM5xx-2ETH do not pro-
vide an FBP interface.
1.1.1.3 Technical Data
The System Data of AC500 and S500
Ä Chapter 2.6.1 “System Data AC500” on page 1248 are
valid for standard version.
The System Data of AC500-XC Ä Chapter 2.7.1 “System Data AC500-XC” on page 1309 are
valid for the XC version.
Only additional details are therefore documented below.
Parameter Value
Connection of the supply voltage 24 VDC
at the terminal base of the processor
module
removable 5-pin terminal block spring type
Slots TB511: 1 processor module, 1 communication
module
TB521 / TB523: 1 processor module, 2 communi-
cation modules
TB541: 1 processor module, 4 communication
modules
Processor module interfaces at TB5x1 I/O bus, COM1, COM2, FBP
Processor module interfaces at TB5x3 I/O bus, COM1
Processor module network interfaces TB5x1-ETH / PM5xx-ETH: Ethernet
TB523-2ETH / PM523-2ETH: 2x Ethernet
TB5x1-ARCNET / PM5xx-ARCNET: ARCNET
Net weight (terminal base without pro-
cessor module)
TB511: 175 g
TB521: 200 g
TB541: 250 g
Mounting position Horizontal or vertical
Device Specifications
Terminal Bases (AC500 Standard) > TB51x-TB54x
2019/04/17 3ADR010121, 13, en_US 11