ABB AC500 PLC - Internal Data Exchange; I;O Configuration; Parameterization

Internal Data Exchange
Digital inputs (bytes) 0
Digital outputs (bytes) 0
Counter input data (words) 8
Counter output data (words) 8
I/O Configuration
The module does not store configuration data itself. It gets its parameterization data from the
master device of the I/O bus (CPU or bus module) during power-up of the system.
Hence, replacing I/O modules is possible without any re-parameterization via software.
Parameterization
Firmware version Configuration
Firmware version > V2.0.0 The arrangement of the parameter data is per-
formed by Control Builder Plus/ Automation
Builder software.
The parameter data directly influences the functionality of modules.
For non-standard applications, it is necessary to adapt the parameters to your system configu-
ration.
Module: Module slot address: Y = 1...10
For non-standard applications, it is necessary to adapt the parameters to your system configu-
ration.
Module slot address: Y = 1...7
No. Name Value Internal
value
Internal
value,
type
Default Min. Max. EDS
Slot/
Index
1 Module
ID
Internal 1500
1
)
Word 1500
0x05dc
0 65535 0x0Y01
2 Ignore
module
2
)
No
Yes
0
1
Byte No
0x00
not for
FBP
3 Param-
eter
length in
bytes
Internal 37 Byte 37-CPU
37-FBP
0 255 0x0Y02
4 Check
supply
Off
On
0
1
Byte On
0x01
0 1 0x0Y03
5 Analog
data
format
Default 0 Byte Default
0x00
0x0Y04
Device Specifications
I/O Modules > Analog I/O Modules
2019/04/17 3ADR010121, 13, en_US 555