1.4.4.1 Technical Data
The System Data of AC500 and S500
Ä
Chapter 2.6.1 “System Data AC500” on page 1248 are
valid for standard version.
The System Data of AC500-XC
Ä
Chapter 2.7.1 “System Data AC500-XC” on page 1309 are
valid for the XC version.
Only additional details are therefore documented below.
Parameter Value
Number of I/O channels per module Max. 24 (depending on the inserted bus
module)
Distribution of the channels into groups 3 groups of max. 8 channels each (2.0...2.7,
3.0...3.7, 4.0...4.7), the allocation of the chan-
nels is given by the inserted bus module
Network interface connector 10 screw or spring terminals (1.0...1.9)
Rated voltage 24 VDC
Max. permitted total current 10 A via the supply terminals (UP, UP3 and
ZP)
Earthing Direct connection to the earthed DIN rail or via
the screws with wall mounting
Screw terminals Front terminal, conductor connection vertically
with respect to the printed circuit board
Spring terminals Front terminal, conductor connection vertically
with respect to the printed circuit board
Weight 200 g
Mounting position Horizontal or vertical
1.4.4.2 Ordering Data
Part No. Description Product Life Cycle Phase *)
1SAP 211 400 R0001 TU517, terminal unit, 24 VDC, screw
terminals
Active
1SAP 211 200 R0001 TU518, terminal unit, 24 VDC, spring
terminals
Active
1SAP 411 200 R0001 TU518-XC, terminal unit, 24 VDC,
spring terminals, XC version
Active
*) For planning and commissioning of new installations use modules in Active
status only.
1.4.5 TU520-ETH for PROFINET Communication Interface Modules
● TU520-ETH, 2 RJ45 interfaces for connection to PROFIBUS network, 3 removable connec-
tors for bus systems
● TU520-ETH-XC, 2 RJ45 interfaces for connection to PROFIBUS network, 3 removable con-
nectors for bus systems, XC version
Terminal Units (AC500 Standard) > TU520-ETH for PROFINET Communication Interface Modules
2019/04/17 3ADR010121, 13, en_US 161
To Next Page
Loading...
