Number of cores per terminal Conductor type Cross section
1 with wire end ferrule without plastic
sleeve
Flexible 0.08 mm² to 2.5 mm²
1 with wire end ferrule with plastic
sleeve
Flexible 0.14 mm² to 1.5 mm²
2 Solid 0.08 mm² to 1.5 mm²
2 Flexible 0.08 mm² to 1.5 mm²
2 with TWIN wire end ferrule (length
10 mm) with plastic sleeve
Flexible 2 x 0.5 mm² to 2 x 1.0 mm²
2 with separate wire end ferrule
without plastic sleeve
Flexible 0.08 mm² to 0.75 mm²
Front terminal, conductor connection vertically with respect to the printed circuit board.
Parameter Value
Type Front terminal
Degree of protection IP 20
Stripped conductor end 9 mm, min. 8 mm
Needed tool Slotted screwdriver
Dimensions 2.5 x 0.4 to 3.5 x 0.5 mm, screwdriver must be at least 15 mm
free of insulation at the tip
Number of cores per terminal Conductor type Cross section
1 Solid 0.08 mm² to 2.5 mm²
1 Flexible 0.08 mm² to 2.5 mm²
1 with wire end ferrule Flexible 0.25 mm² to 1.5 mm²
2 Solid Not intended
2 Flexible Not intended
2 with TWIN wire end ferrule (length
10 mm) with plastic sleeve
Flexible 2 x 0.25 mm² or 2 x 0.5 mm² or
2 x 0.75 mm², with square cross-sec-
tion of the wire-end ferrule also
2 x 1.0 mm²
Terminal type:
Spring Terminal
System Assembly, Construction and Connection
AC500 (Standard) > Connection and Wiring
2019/04/17 3ADR010121, 13, en_US 1275
To Next Page
Loading...
