SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
1021
2 Parameters
2.4 Parameters for write protection and know-how protection
2.4.2 Parameters with "KHP_WRITE_NO_LOCK"
The following list contains the parameters with the "KHP_WRITE_NO_LOCK" attribute.
These parameters are not affected by the know-how protection.
Product: SINAMICS G130/G150, Version: 4702900, Language: eng, Type: KHP_WRITE_NO_LOCK
p0003 BOP access level / BOP acc_level
p0009 Device commissioning parameter filter / Dev comm par_filt
p0124[0...n] Power unit detection via LED / PU detection LED
p0124[0...n] Main component detection using LED / M_comp detect LED
p0144[0...n] Sensor Module detection via LED / SM detection LED
p0154 DRIVE-CLiQ Hub Module detection via LED / Hub detection LED
p0154 Terminal Module detection via LED / TM detection LED
p0972 Drive unit reset / Drv_unit reset
p0976 Reset and load all parameters / Reset load all par
p0977 Save all parameters / Save all par
p2035 Fieldbus interface USS PIV drive object number / Fieldbus USS DO_no
p2040 Fieldbus interface monitoring time / Fieldbus t_monit
p2102 BI: Acknowledge all faults / Ackn all faults
p2111 Alarm counter / Alarm counter
p3100 RTC time stamp mode / RTC t_stamp mode
p3101[0...1] RTC set UTC time / RTC set UTC
p3103 RTC synchronization source / RTC sync_source
p3950 Service parameter / Serv par
p3981 Faults acknowledge drive object / Faults ackn DO
p3985 Master control mode selection / PcCtrl mode select
p7761 Write protection / Write protection
p7770 NVRAM action / NVRAM action
p8550 AOP LOCAL/REMOTE / AOP LOCAL/REMOTE
p8805 Identification and maintenance 4 configuration / I&M 4 config
p8806[0...53] Identification and Maintenance 1 / I&M 1
p8807[0...15] Identification and Maintenance 2 / I&M 2
p8808[0...53] Identification and Maintenance 3 / I&M 3
p8809[0...53] Identification and Maintenance 4 / I&M 4
p8829 CBE2x remote controller number / CBE2x rem ctrl num
p8835 CBE20 firmware selection / CBE20 FW sel
p8839[0...1] PZD interface hardware assignment / PZD IF HW assign
p8840 COMM BOARD monitoring time / CB t_monit
p9210 Flashing component number / Flash comp_no
p9211 Flash function / Flash fct.
p9484 BICO interconnections search signal source / BICO S_src srch
To Next Page
Loading...
