2 Parameters
2.2 List of parameters
SINAMICS G130/G150
990 List Manual (LH2), 04/2014, A5E03263479A
Dependency: Refer to: p10017, p10040
Note: If a safety function is assigned to an input (e.g. via p10022), then the following applies:
- logical "0": Safety function is selected
- logical "1": Safety function is de-selected
The interrelationship between the logical level and the external voltage level at the input depends on the
parameterization (refer to p10040) of the input as either NC or NO contact and is aligned to the use of a safety
function:
With 24 V at the input, NC contacts have a logical "1" level, for 0 V at the input, a logical "0" level.
This means that an NC/NC contact parameterization of 0 V at both inputs of the F-DI selects the safety function, for
24 V at both inputs, de-selects the safety function.
With 24 V at the input, NO contacts have a logical "0" level, for 0 V at the input, a logical "1" level.
This means that for an NC/NO contact parameterization, the level 0 V/24 V selects the safety function, the level 24
V/0 V de-selects the safety function.
F-DI: Failsafe Digital Input
Description: Displays the status of the digital outputs at the Terminal Module 54F (TM54F).
TM54F_MA (master): display of DO-
TM54F_SL (slave): display of DO+
Note: F-DO: Failsafe Digital Output
Description: Displays the status of the digital inputs at the Terminal Module 54F (TM54F).
07 F-DI 7 Logical 1 Logical 0 2851
08 F-DI 8 Logical 1 Logical 0 2851
09 F-DI 9 Logical 1 Logical 0 2851
r10052.0...3 CO/BO: SI TM54F digital outputs status / SI DO status
TM54F_MA,
TM54F_SL
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DO 0 High Low 2853
01 DO 1 High Low 2853
02 DO 2 High Low 2853
03 DO 3 High Low 2853
r10053.0...3 CO/BO: SI TM54F digital inputs 20 ... 23 status / SI DI 20...23 stat
TM54F_SL Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: 2848
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 DI 20 High Low 2853
01 DI 21 High Low 2853
02 DI 22 High Low 2853
03 DI 23 High Low 2853
To Next Page
Loading...
