Siemens SINAMICS G150 - IE Subnet Mask of Station Active; IE Subnet Mask Act; IE DHCP Mode of Station Active; IE DHCP Mode Act; IE MAC Address of Station; IE MAC of Station; PN Name of Station; PN Name Stat

SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
823
2 Parameters
2.2 List of parameters
Description: Displays the active subnet mask for the Industrial Ethernet interface (X127) on the Control Unit.
Description: Displays the active DHCP mode for the Industrial Ethernet interface (X127) on the Control Unit.
Note: If value = 0:
DHCP deactivated.
If value = 2:
DHCP activated. The MAC address of this interface is used for client identification.
If value = 3:
DHCP activated. The station name of this interface is used for client identification.
Description: Displays the MAC address for the Industrial Ethernet interface (X127) on the Control Unit.
Description: Sets the station name for the onboard PROFINET interface on the Control Unit.
The active station name is displayed in r8930.
Note: An ASCII table (excerpt) can be found, for example, in the appendix to the List Manual.
The interface configuration (p8920 and following) is activated with p8925.
The parameter is not influenced by setting the factory setting.
PN: PROFINET
r8913[0...3] IE Subnet Mask of Station active / IE Subnet Mask act
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 1
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 255 -
r8914 IE DHCP mode of station active / IE DHCP mode act
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 1
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 255 -
r8915[0...5] IE MAC Address of Station / IE MAC of Station
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 1
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0000 hex 00FF hex -
p8920[0...239] PN Name of Station / PN Name Stat
CU_G130_PN,
CU_G150_PN
Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: - Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -