SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
789
2 Parameters
2.2 List of parameters
Description: Displays the receive configuration data for the COMM BOARD.
Description: Connector output for interconnecting the PZD (setpoints) received via interface 2 in the word format.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
Note: IF2: Interface 2
PZD1 to PZD2 are displayed bit-serially in r8890 to r8891.
Description: Connector output for interconnecting the PZD (setpoints) received via interface 2 in the word format.
Index: [0] = PZD 1
[1] = PZD 2
[2] = PZD 3
[3] = PZD 4
[4] = PZD 5
[5] = PZD 6
[6] = PZD 7
[7] = PZD 8
[8] = PZD 9
[9] = PZD 10
[10] = PZD 11
[11] = PZD 12
[12] = PZD 13
[13] = PZD 14
[14] = PZD 15
r8849[0...139] COMM BOARD receive configuration data / CB r config_dat
CU_G130_DP (COMM
BOARD, PROFINET
CBE20),
CU_G130_PN (COMM
BOARD, PROFINET
CBE20),
CU_G150_DP (COMM
BOARD, PROFINET
CBE20),
CU_G150_PN (COMM
BOARD, PROFINET
CBE20)
Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: -
P-Group: Communications Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r8850[0...9] CO: IF2 PZD receive word / IF2 PZD recv word
B_INF Can be changed: - Calculated: - Access level: 3
Data type: Integer16 Dyn. index: - Func. diagram: 2491
P-Group: Communications Units group: - Unit selection: -
Not for motor type: - Scaling: 4000H Expert list: 1
Min Max Factory setting
- - -
r8850[0...19] CO: IF2 PZD receive word / IF2 PZD recv word
CU_G130_DP,
CU_G130_PN,
CU_G150_DP,
CU_G150_PN
Can be changed: - Calculated: - Access level: 3
Data type: Integer16 Dyn. index: - Func. diagram: 2491
P-Group: Communications Units group: - Unit selection: -
Not for motor type: - Scaling: 4000H Expert list: 1
Min Max Factory setting
- - -
To Next Page
Loading...
