2 Parameters
2.2 List of parameters
SINAMICS G130/G150
606 List Manual (LH2), 04/2014, A5E03263479A
Description: Setting to invert the signals at the digital outputs of the Terminal Board 30 (TB30).
Note: DO: Digital Output
Description: Setting to invert the signals at the digital outputs of Terminal Module 31 (TM31).
Note: DO: Digital Output
DI/DO: Bidirectional Digital Input/Output
Description: Displays the actual input voltage at the analog inputs for Terminal Board 30 (TB30).
Note:
For p4056[x] = 3 (unipolar current input monitored (+4 mA ... +20 mA)) the following applies:
A current less than 4 mA is not displayed in r4052[x] - but instead r4052[x] = 4 mA is output.
Index: [0] = AI 0 (X482.1/X482.2)
[1] = AI 1 (X482.3/X482.4)
Note: AI: Analog Input
p4048 TB30 invert digital outputs / TB30 DO inv
TB30 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 Dyn. index: - Func. diagram: 9102
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0000 bin
Bit field: Bit Signal name 1 signal 0 signal FP
00 DO 0 (X481.5) Inverted Not inverted -
01 DO 1 (X481.6) Inverted Not inverted -
02 DO 2 (X481.7) Inverted Not inverted -
03 DO 3 (X481.8) Inverted Not inverted -
p4048 TM31 invert digital outputs / TM31 DO inv
TM31 Can be changed: U, T Calculated: - Access level: 1
Data type: Unsigned32 Dyn. index: - Func. diagram: 9556, 9560,
9562
P-Group: Commands Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - 0000 0000 0000 0000 bin
Bit field: Bit Signal name 1 signal 0 signal FP
00 DO 0 (X542.1 - 3) Inverted Not inverted -
01 DO 1 (X542.4 - 6) Inverted Not inverted -
08 DI/DO 8 (X541.2) Inverted Not inverted -
09 DI/DO 9 (X541.3) Inverted Not inverted -
10 DI/DO 10 (X541.4) Inverted Not inverted -
11 DI/DO 11 (X541.5) Inverted Not inverted -
r4052[0...1] CO: TB30 analog inputs actual input voltage / TB30 AI U_inp act
TB30 Can be changed: - Calculated: - Access level: 1
Data type: FloatingPoint32 Dyn. index: - Func. diagram: 9104
P-Group: Terminals Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- [V] - [V] - [V]
To Next Page
Loading...
