Siemens SINAMICS G150 - CO;BO: si TM54 F Status; si Stat; SI TM54 F Password Input; si Password Inp; SI TM54 F Password New; si Password New; SI TM54 F Password Acknowledgement; si Ackn Password

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
992 List Manual (LH2), 04/2014, A5E03263479A
Description: Display and BICO output for the status of the Terminal Module 54F (TM54F).
Description: Enters the Safety Integrated password for the Terminal Module 54F (TM54F).
This password is required to change the safety-relevant parameters.
Description: Enters the new Safety Integrated password for the Terminal Module 54F (TM54F).
Dependency: A change made to the Safety Integrated password must be acknowledged in the following parameter:
Refer to: p10063
Description: Acknowledgement of the new Safety Integrated password for the Terminal Module 54F (TM54F).
Dependency: Refer to: p10062
Note: The new password entered into p10062 must be re-entered in order to acknowledge.
p10062 = p10063 = 0 is automatically set after the new Safety Integrated password has been successfully
acknowledged.
r10056.0 CO/BO: SI TM54F status / SI stat
TM54F_MA Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
Bit field: Bit Signal name 1 signal 0 signal FP
00 Test stop status Active Inactive -
p10061 SI TM54F password input / SI password inp
TM54F_MA,
TM54F_SL
Can be changed: U, T Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: 2847
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0000 hex FFFF FFFF hex 0000 hex
p10062 SI TM54F password new / SI password new
TM54F_MA,
TM54F_SL
Can be changed: C2(95) Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: 2847
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0000 hex FFFF FFFF hex 0000 hex
p10063 SI TM54F password acknowledgement / SI ackn password
TM54F_MA,
TM54F_SL
Can be changed: C2(95) Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: 2847
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0000 hex FFFF FFFF hex 0000 hex