Siemens SINAMICS G150 - Control Word, Faults;Alarms

3 Function diagrams 3.6 Internal control/status words
SINAMICS G130/G150
1106 List Manual (LH2), 04/2014, A5E03263479A
Fig. 3-67 2546 – Control word, faults/alarms
- 2546 -
Function diagram
87654321
fp_2546_51_eng.vsd
DO: All objects
SINAMICS
08.05.08 V04.07.00
Internal control/status words - Control word, faults/alarms
p2103[C]1. Acknowledge
p2102Ackn all faults
p2105[C]3. Acknowledge
Pulse generator
11
12
13
14
15
Reserved
Control word, faults/alarms
Reserved
Reserved
Reserved
Reserved
Reserved
Reserved
= Acknowledge fault
Reserved
Reserved
= External alarm 1 (A07850)
= External alarm 2 (A07851)
= External alarm 3 (A07852)
= External fault 1 (F07860)
= External fault 3 (F07862)
= External fault 2 (F07861)
PROFIdrive bit
9
10
8
7
6
5
4
3
2
1
0
Bit No.
To alarm buffer [8065.1]r2138.11
To fault buffer [8060.1]
r2138.13
To fault buffer [8060.1]r2138.14
r2138
STW faults/alarms
p2112[C] (1)
p2116[C] (1)
p2117[C] (1)
p2106[C] (1)
p2107[C] (1)
4000.00 μs
To fault buffer [8060.1]
r2138.15
To alarm buffer [8065.1]r2138.12
To alarm buffer [8065.1]r2138.10
To fault buffer [8060.1]
r2138.7
p2108[C] (1)
p3111[C] (1)
p3112[C] (0)
T0
p3110 [ms]
<2>
<1>
p2104[C]2. Acknowledge
<2>
<2>
<2>
<2>
<2>
<2>
<2>
<2>
<2>
<2>
1
1
1
1
1
1
<1> This parameter refers to the Control Unit and is
used as source to simultaneously acknowledge
all faults on all drive objects.
<2> These parameters refer to the Command Data Sets (CDS) depending on the
individual drive object (DO).