Siemens SINAMICS G150 - SI Diagnostics Component Replacement; Diag Comp_Replace; SI Crosswise Comparison List (Control Unit); si Cdc_List CU; SI Diagnostics STOP F (Control Unit); si Diag STOP F CU; SI Actual Checksum si Parameters (Control Unit); si Act_Checksum CU

2 Parameters
2.2 List of parameters
SINAMICS G130/G150
938 List Manual (LH2), 04/2014, A5E03263479A
Description: Displays the component number for the first 10 replaced safety-relevant components.
Dependency: Refer to: r9776
Note: This parameter does not exist for a Control Unit and Terminal Module.
Description: Displays the number of the data that are being presently compared crosswise on the Control Unit.
The content of the list of crosswise-compared data is dependent upon the particular application.
Dependency: Refer to: r9894
Note: Example:
r9794[0] = 1 (monitoring clock cycle)
r9794[1] = 2 (enable safety functions)
r9794[2] = 3 (F-DI changeover, tolerance time)
...
A complete list of numbers for crosswise-compared data items appears in fault F01611.
Description: Displays the number of the cross-compared data which has caused STOP F on the Control Unit.
Dependency: Refer to: r9895
Note: A complete list of numbers for crosswise-compared data items appears in fault F01611.
Description: Displays the checksum over the checked Safety Integrated parameters on the Control Unit (actual checksum).
Dependency: Refer to: p9799, r9898
r9793[0...9] SI diagnostics component replacement / Diag comp_replace
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned8 Dyn. index: - Func. diagram: -
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r9794[0...19] SI crosswise comparison list (Control Unit) / SI CDC_list CU
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned16 Dyn. index: - Func. diagram: 2802
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r9795 SI diagnostics STOP F (Control Unit) / SI diag STOP F CU
VECTOR_G Can be changed: - Calculated: - Access level: 2
Data type: Unsigned32 Dyn. index: - Func. diagram: 2802
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -
r9798 SI actual checksum SI parameters (Control Unit) / SI act_checksum CU
VECTOR_G Can be changed: - Calculated: - Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: 2800
P-Group: Safety Integrated Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
- - -