Siemens SINAMICS G150 - Assignment Parameter 10 in Reference to P514[9]; Bicolist10_Ref10; Controller Gain System of Units; Ctrl_Gain Unit_Sys

SINAMICS G130/G150
List Manual (LH2), 04/2014, A5E03263479A
211
2 Parameters
2.2 List of parameters
The significance of the assignment parameters is as follows:
p523[0] BiCo number assigned p514[8] (reference quantity 09)
..
p523[19] BiCo number assigned p514[8] (reference quantity 09)
Dependency: Refer to: p0514
Description: Assignment parameter for user-specific scaling.
By indexing the assignment parameter p524[0..19], a total of 20 BiCos are available, which should be scaled
corresponding to the user-specific scaling.
The significance of the assignment parameters is as follows:
p524[0] BiCo number assigned p514[9] (reference quantity 10)
..
p524[19] BiCo number assigned p514[9] (reference quantity 10)
Dependency: Refer to: p0514
Description: Sets the system of units for the controller gains.
Value: 0: Representation physical/% (p0505)
1: Representation no dimensions (referred)
Note: For p0528 = 0 (physical/%), the following applies:
Using p0505, the dependent parameters can be changed over between physical and % representation.
For SERVO (r0107) the following applies:
The parameter is pre-assigned a value of 0 and cannot be changed.
Description: Sets the system of units for the controller gains.
Value: 0: Representation physical/% (p0505)
1: Representation no dimensions (referred)
Note: For VECTOR (r0107) the following applies:
The parameter is pre-assigned a value of 1 and cannot be changed.
p0524[0...19] Assignment parameter 10 in reference to p514[9] / BiCoList10_ref10
B_INF, VECTOR_G Can be changed: T Calculated: CALC_MOD_ALL Access level: 3
Data type: Unsigned32 Dyn. index: - Func. diagram: -
P-Group: Communications Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 4294967295 0
p0528 Controller gain system of units / Ctrl_gain unit_sys
ENC Can be changed: C2(5) Calculated: - Access level: 4
Data type: Integer16 Dyn. index: - Func. diagram: -
P-Group: Applications Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 0
p0528 Controller gain system of units / Ctrl_gain unit_sys
VECTOR_G Can be changed: C2(5) Calculated: - Access level: 4
Data type: Integer16 Dyn. index: - Func. diagram: -
P-Group: Applications Units group: - Unit selection: -
Not for motor type: - Scaling: - Expert list: 1
Min Max Factory setting
0 1 1